Engineering Design/Drafting Technology: AS

Associate of Science | 64 credits minimum; 22 credits beyond AAS

Program Website
Academic Advising

Program Description
The AS Degree focusing on Engineering Design/Drafting Technology is designed for students who have completed an Engineering Design Manufacturing Technology: AAS and who are interested in transferring to UVU Technology Management Bachelor’s degree. The program allows the courses that are required in the AAS degree to be combined with additional General Education courses to satisfy AS degree requirements.

Transfer/Articulation Information
Please refer to the Student Resources section of the SLCC University Transfer webpage.

Estimated Cost for Students
Tuition and student fees: http://www.slcc.edu/student/financial/tuition-fees.aspx

Note: Fees may vary based upon specific registration and are subject to change.

General Education Requirements

In addition to the General Education Requirements for the Engineering Design Manufacturing Technology: AAS (CTE) degree, complete the following.

Program General Education Notes

REQUIRED:

Institutional Requirements:

Communication (CM): Any
Communication (CM)
course
International & Global (IG): Any
International & Global (IG)
 course
Lifelong Wellness (LW): Any
Lifelong Wellness (LW)
course

Distribution Areas:

Choose one course (three credit hours) from each of the following distribution areas except for the one selected for the AAS degree. One of the courses must also be a Diversity course (DV).

NOTE: COMM 2110 satisfies Communication (CM) requirement.

Required Courses

See required course list from the Engineering Design Manufacturing Technology program.

Emphasis Courses

See emphasis courses from the Engineering Design Manufacturing Technology program.